**** BEGIN LOGGING AT Tue Jun 27 03:00:08 2017
Jun 27 16:02:19 <thetransformerr[> hi ds2:
Jun 27 16:02:50 <thetransformerr[> did you further checked out maxq for interfacing
Jun 27 16:05:52 <thetransformerr[> can you please checkout what happens if we place two boards facing each other and then trigger both at same time
Jun 27 16:06:31 <thetransformerr[> and if we can just enable receiver in one board and transmitter in one board?
Jun 27 16:09:11 <thetransformerr[> however I also wanted to ask how much cpu is occupied if we gpio through sysfs
Jun 27 19:03:14 <ravikp7> jkridner: Hi, I'm using promise chaining for the async transfers. Please review the code in dev branch
Jun 27 20:07:40 <nerdboy> thetransformerr[: afaik that's what he did, boards in reset mode and a diode on the tx board
Jun 27 20:08:21 <nerdboy> the pwm/prudaq loop with a simple filter should work for now
Jun 27 20:09:03 <nerdboy> when you get the boards you will need a better soldering setup than we have
Jun 27 20:09:24 <nerdboy> the diode goes on one end of a tiny resistor
Jun 27 21:25:50 <thetransformerr[> pwm/prudaq loop is almost ready, I would show it to you once I complete it
Jun 27 22:14:23 <nerdboy> wormo calls 'em "flea" resistors...
Jun 28 02:18:25 <ds2> relatively quiet channel this year
**** ENDING LOGGING AT Wed Jun 28 03:00:04 2017