**** BEGIN LOGGING AT Tue Nov 23 02:59:57 2021
Nov 23 11:43:51 <set_> Did you hear that Oxygen and Magnesium got together?
Nov 23 11:43:56 <set_> OMg!
Nov 23 13:39:27 <johanhenselmans> zmatt: I got this from (for example) ‘config-pin -l P9.24’ which results in Available modes for P9_24 are: default gpio gpio_pu gpio_pd gpio_input uart can i2c pru_uart pruin
Nov 23 13:49:30 <johanhenselmans> I thought that, in the case that a button is pressed, gpio_input should be an appropriate name for the configuration. But any other suggestion is welcome.
Nov 23 14:26:17 <zmatt> default is fine
Nov 23 14:27:20 <zmatt> pinmux has no control over whether a pin is input or output
Nov 23 14:27:51 <zmatt> that's done via the gpio interface
Nov 23 14:30:05 <zmatt> johanhenselmans: and like I said earlier, the modes "gpio", "gpio_pu", "gpio_pd" only differ in how the weak internal pull-up/down resistor is configured, which is usually not very important.  (but it's recommended to avoid disabling internal pull (i.e. use mode "gpio") unless you have a very good reason to do so)
Nov 23 14:31:18 <zmatt> hmm, (*i.e. avoid using mode "gpio") would have been a better way to phrase that
Nov 23 14:31:54 <zmatt> the "gpio_input" mode appears to be a mistake and is just the same as "gpio"
Nov 23 17:42:55 <Guest70> Hello everyone, I recently purchased a Beaglebone Green and http://192.168.7.2/ is not working? Should I first reflash it?
Nov 23 21:27:49 <Guest61> Hi, what is the operating temperature range of the BeagleBone-AI board?  In one of the support pages, the web site has the temperature range of the Sitara SOC, but not of the PCBA itself.  Thank you.
**** ENDING LOGGING AT Wed Nov 24 02:59:56 2021