**** BEGIN LOGGING AT Thu Jan 13 02:59:56 2022
Jan 13 14:51:10 <Guest9> i have an issue. i have designed a cape for the bbb but im finding as soon as i plug the bbb in to the cape. it gets fried ie the power light flashes quickily once.
Jan 13 14:51:43 <Guest9> the bbb is powered via the 5v vdd pin and gnd pins.
Jan 13 14:52:52 <Guest9> about 32 gpio pins are then connected to a level shifter and have noticed the level shifters are putting a voltage of 3.3V back to the gpio pins. not sure if this could be the issue or not
Jan 13 15:24:32 <vd_> zmatt: so it is safe to assume that the beaglebone blue/green/enhanced are derived from the black, right?
Jan 13 18:05:11 <zmatt> they are yes
Jan 13 18:09:53 <dkaiser> I am planning to do so debugging of the Debian (Bullseye) installer on beaglebone black.  Any recommendations?  Setting up a debian installer cross build environment?
Jan 13 18:20:27 <rcn-ee> dkaiser, disable 'quiet' boot the current version, and report what fails...
Jan 13 18:20:45 <rcn-ee> i think there are a few kernel bugs, that haven't been merged into debian's kernel..
Jan 13 18:23:34 <rcn-ee> dkaiser, pretty sure the current bbb bug is: enable: CONFIG_TI_CPSW_SWITCHDEV
Jan 13 18:46:40 <dkaiser> rcn-ee, the installed bullseye system works on the BBB, except that I must manually configure the ethernet system as the debian installer failed to detect it.
Jan 13 18:47:48 <dkaiser> my goal is to identify what is causing the failure to detect the ethernet driver during the debian installer.
Jan 13 18:50:35 <dkaiser> rcn-eee, what methods can you suggest for "disable 'quiet' boot of the current version...?
Jan 13 19:01:34 <rcn-ee> pretty sure the last issue, was that CONFIG_TI_CPSW_SWITCHDEV was not set ot built-in or module.. thus ethenet never comes up..
Jan 13 22:36:06 <zmatt> dkaiser: what do you mean with "methods" for disabling quiet boot?  just remove the 'quiet' option from the kernel commandline parameters
Jan 13 22:38:38 <dkaiser> zmatt, thank you
**** ENDING LOGGING AT Fri Jan 14 02:59:56 2022