**** BEGIN LOGGING AT Fri Jan 13 02:59:56 2023
Jan 13 03:01:02 <set_> Just remember to push your seat in after standing from sitting and other things too.
Jan 13 03:04:00 <set_> I received a warning: gmake[2]: warning:  Clock skew detected.  Your build may be incomplete.
Jan 13 04:44:19 <Guest46> Hi
Jan 13 04:44:32 <Guest46> What is a Zen Cape (Green or Red)?
Jan 13 11:56:54 <rah> anyone have an idea why the Debian linux-kernel-armmp might not boot on a Beagleboard X-15?
Jan 13 11:57:02 <rah> it just sits there
Jan 13 11:57:21 <rah> Starting kernel ...
Jan 13 15:06:15 <rah> how do I build a mainline kernel for the Beagleboard X-15?  I can't find any information on how to do that
Jan 13 17:51:03 <rcn-ee> @rah which version of linux-kernel-armmp ?
Jan 13 17:52:41 <rcn-ee> rah: mainline omap2plus_defconfig should boot on the x15, but 6.1.x-rc had a few issues on that board during development.
Jan 13 20:08:31 <rah> rcn-ee: 4.19.0-21-armmp
Jan 13 21:19:51 <rcn-ee> @rah 4.19! probally not..
Jan 13 21:36:20 <rah> it was using ttyS2 for the console rather than ttyO2; with that fixed, I can see it booting
Jan 14 00:37:23 <zmatt> rah: I guess your kernel doesn't have CONFIG_SERIAL_8250_OMAP_TTYO_FIXUP enabled?
Jan 14 00:59:55 <set_> New person here, does anyone know the enable pin/GPIO on the BBAI-64 for the Servo Cape off hand?
Jan 14 01:00:15 <set_> I need to research but I am getting odd results so far...
Jan 14 01:02:49 <set_> GPIO0_16!
Jan 14 01:03:23 <set_> That blurt was for the Servo Cape users!
Jan 14 01:05:57 <set_> Does the AI64 work like the am335x/BBB boards in that I use 0 * 32 + 16 = MY_PIN?
Jan 14 01:06:03 <set_> Probably not, heh?
Jan 14 01:34:03 <set_> Does this mean... line 16: "P8_10" "pca9685-enable" output active-high [used] ...that I need to do nothing and it is already active-high?
Jan 14 02:04:48 <set_> Whelp... I think I got it but the server does not run. Argh.
**** ENDING LOGGING AT Sat Jan 14 02:59:56 2023