**** BEGIN LOGGING AT Mon Dec 10 03:00:00 2018 Dec 10 09:13:24 https://lh3.googleusercontent.com/-TR9LNYFUjsU/XA4sH_j8tzI/AAAAAAAABv0/KQGLlmG1xSYv35sXkMKlDniJnnNOAeU0QCL0BGAYYCw/h1853/704035464178809750%253Faccount_id%253D7 Dec 10 21:44:23 DocScrutinizer05: ShadowJK: spinal84 said he measured the current from the battery and it is off by 1.5 compared to the reported value. kernel shows 230547, ammeter 0.155A Dec 10 21:44:28 any thoughts? Dec 10 21:46:29 bq27200.sh script (and also kernel) uses 20mOhm resistor sense value... it is correct? Dec 10 21:47:23 Pali: we discussed that yesterday, and both DocScrutinizer05 and ShadowJK said it is ok Dec 10 21:47:52 however, the measurement (if done properly) shows another story Dec 10 21:48:36 * freemangordon boots his dev device Dec 10 21:52:01 spinal84: do you remember which reg is LMD? I don't have the datasheet around Dec 10 21:52:26 1 moment Dec 10 21:52:30 0x76 Dec 10 21:52:37 0x76 Dec 10 21:52:43 thanks Dec 10 21:53:02 0x76=0x2d Dec 10 21:53:07 sorry, that's ilmd Dec 10 21:53:08 0x13 - 0x12 Dec 10 21:53:13 ok Dec 10 21:53:26 0x12=0x2cf5 Dec 10 21:53:40 0x12 is low byte Dec 10 21:54:26 so you need swap values to calculate if you get it from i2c Dec 10 21:56:02 this is reported as short Dec 10 21:57:02 LMD is reported in units of 3.57 µVh per count, so the formula will be: LMD * 0.00357 / Rs, if i'm right :) Dec 10 21:58:21 2,0543565 if you are right :) Dec 10 21:59:20 1,369571 if RS is 30 Dec 10 21:59:20 LMD * 3.57 / RS from what i see Dec 10 21:59:43 ok, have to go now, will continue tomorrow Dec 10 21:59:45 that's if we're calculating for mAh Dec 10 21:59:52 freemangordon, where did you get such a good battery? :) Dec 10 22:00:08 polarcell ;) Dec 10 22:00:52 Pali: ^^^ Dec 10 22:01:00 what do you think about that? Dec 10 22:02:06 this is reported on 2.6.28.10-power53 Dec 10 22:03:24 WTF is 3.57μVh ? Dec 10 22:03:41 it's voltage units used by bq27200 to measure current Dec 10 22:03:45 what have volts to do with a discharge? Dec 10 22:03:59 current is measured by measuring voltage on sense resistor :) Dec 10 22:04:08 ah, I see :) Dec 10 22:04:15 that's why we need to know the sense resistor to calculate true current Dec 10 22:04:37 yeah, right Dec 10 22:05:42 anyway, I am afk, will continue tomorrow Dec 10 22:05:46 night Dec 10 22:05:54 bq27200 doesn't have FPU unit, so it only can provide integer values, that's why 3.57 mV is used as single unit Dec 10 22:05:56 cya Dec 10 22:21:02 Is maemo still being actively maintained? Like is there anything new for the n900? Dec 10 22:22:33 sure Dec 10 22:22:38 see maemo-leste Dec 10 22:24:22 Oh awesome, thanks! Dec 10 22:31:36 “ammeter” is a misnomer because the beginning of this word is from a unit instead of what is being measured. It is an electric current meter that uses the unit named ampere but it could use a different unit if there was one. Dec 10 22:37:27 spinal84: Decimal values can be used without using floating point. Dec 10 22:39:11 brolin_empey, i was just kidding Dec 10 22:39:36 bq27200 is just a simple ic, it's not a CPU+FPU Dec 10 22:41:48 spinal84: OK, I thought you were serious. Dec 10 22:45:06 Not in this channel but someone who was writing about SimCity 2000 long after its release seemed to seriously believe that a microwave oven is more powerful than an 80386-based computer. (fail) Dec 10 23:38:09 freemangordon: ue bq27k-detail2 Dec 10 23:41:55 wtf is spinning busy in my HD? Dec 10 23:48:09 https://pastebin.com/FthfxK61 Dec 10 23:50:42 killed mediaplayer and CPU goes down to 31% Dec 10 23:52:16 plausible 12% for htop, rest for Xorg etc **** ENDING LOGGING AT Tue Dec 11 03:00:01 2018