**** BEGIN LOGGING AT Sat Feb 24 02:59:58 2007 Feb 24 23:13:21 hello Feb 24 23:13:58 I'm trying to reflash a "bricked" dsl router Feb 24 23:14:16 does anyone know the openwince jtag tools? Feb 24 23:46:58 seventhguardian: this is how we do it for nslu2: http://www.nslu2-linux.org/wiki/HowTo/RecoverFromABadFlashUsingJTAG Feb 25 00:18:37 I'm using 0.6 Feb 25 00:19:00 but while trying to detect flash I always get the "Flash Not found!" error.. Feb 25 00:19:15 in 0.6 you need to specify the flash start Feb 25 00:19:30 does your version of openwince tools support the processor and flash chip on your board? Feb 25 00:19:50 it should Feb 25 00:20:04 except it reports it as a "Hitachi" ar7300 Feb 25 00:20:11 instead of a Texas instruments.. Feb 25 00:20:54 I wanted to know how to make a device file based on the "discovery" command Feb 25 00:21:25 because I don't trust the existing ar7300 file.. Feb 25 00:25:49 dunno Feb 25 00:29:06 thks anyway.. Feb 25 00:29:14 I'll look around Feb 25 00:29:14 .. Feb 25 00:34:35 btw Feb 25 00:35:00 what does it mean "Unknown bus width!" Feb 25 00:35:01 ? Feb 25 00:35:25 I'm trying to read the internal ram memory but I get this error.. Feb 25 00:36:12 or this when using the peek command: Feb 25 00:36:21 jtag> peek 0x80000000 Feb 25 00:36:22 ImpCode=01000001010000000100000000000000 Feb 25 00:36:22 EJTAG version: 2.6 Feb 25 00:36:22 EJTAG Implementation flags: R4k DINTsup ASID_8 NoDMA MIPS32 Feb 25 00:36:22 ejtag.c(278) Failed to enter debug mode, ctrl=00000000000000001101000000000000 Feb 25 00:36:22 ejtag.c(139) No processor access, ctrl=00000000000000001101000000000000 Feb 25 00:36:24 ejtag.c(139) No processor access, ctrl=00000000000000001101000000000000 Feb 25 00:36:27 bus_read(0x80000000) = 0x00000000 (0) Feb 25 00:36:36 (sorry for the big output..) Feb 25 00:40:03 seventhguardian: sorry, I'm not a openwince expert - I only know how to use it for nslu2. Feb 25 00:40:16 ok thanks.. **** ENDING LOGGING AT Sun Feb 25 02:59:58 2007