**** BEGIN LOGGING AT Wed Jan 13 02:59:57 2010 Jan 13 12:26:54 Hi. Already asked at #electronics but probably some of OpenOCD gurus is available here. I want to use arm-usb-ocd olimex programmer to do atmega128 flashing. Programming flash was already implemented, i added EEPROM programming (will prepare and send a patch later). But how to implement verification architecture-wise? Currently avr flash driver is "nor" (as it is in fact nor memory) but no OCD commands are implemented, hence there's no way to read b Jan 13 12:27:00 ... what's written. How to properly do it architecture-wise? Jan 13 17:21:15 did you try #avr Jan 13 17:21:56 bbl Jan 13 21:06:32 having problems with openocd3.1 freddiechopin winidows build and my Amontec JTAGkey. It says the hardware is not plugged in. Jan 13 21:08:30 my r717 openocd-ftd2xxx works fine Jan 13 21:09:17 I assume it's to do with the dropping of the FTDI libraries, is there anyting else I have to do? Jan 14 01:15:17 try #sparkfun, #electronics #avr **** ENDING LOGGING AT Thu Jan 14 02:59:57 2010