**** BEGIN LOGGING AT Tue Jun 22 02:59:56 2010 Jun 22 05:49:23 <|if3> flash rootfs first? or flash kernel first? Jun 22 05:57:26 doesn't matter as long as you flash both Jun 22 05:57:43 I usually first flash the kernel, as that's faster, then the rootfs and do something else while that's running Jun 22 06:01:12 <|if3> true that Jun 22 06:01:19 <|if3> thanks bud **** BEGIN LOGGING AT Tue Jun 22 10:15:29 2010 Jun 22 10:16:59 PaulFertser: i see, than glamo, memory and nand connected to 'DOWN2OUT' pin of pcf Jun 22 10:17:36 PaulFertser: which supports 'current limiting'. Jun 22 10:18:09 current limiting is simply limiting the current out of the pin Jun 22 10:18:24 It allows the voltge to drop if the current limit is exceeded Jun 22 10:18:55 but we have current limiting register set to 30mA! Jun 22 10:19:02 how this possible? Jun 22 10:19:16 I've not looked at the circuit. Jun 22 10:19:33 i looked... Jun 22 10:19:50 Glamo, memory and nand would probably use more than 30mA I'd imagine Jun 22 10:20:03 Are you sure the register means what you think it means - in that mode Jun 22 10:20:27 yes, i am quite sure Jun 22 10:20:36 address is 0x25 Jun 22 10:20:41 DOWN2MXC Jun 22 10:20:52 0:5 bits for limit Jun 22 10:21:10 Sure that that's not in units of - say - 1mA? Jun 22 10:21:13 10 Jun 22 10:22:00 hm, no. seem i missed one thing. Jun 22 10:22:09 it is limited on 'startup' Jun 22 10:22:12 only Jun 22 10:23:13 If the loads are off - or in a low power state - when the thing is turned on, ... Jun 22 10:23:16 it's ok, seem i took a look to a wrong bit. Jun 22 10:24:11 documentation is a bit misleading Jun 22 10:24:39 it shows value of 01101 as exaple but claims field is 6 bit. Jun 22 10:24:52 so, ok :) Jun 22 10:25:00 no more question... Jun 22 11:01:45 gena2x: just come home, but i see you're fine already :) Jun 22 11:02:05 PaulFertser: yeah :) **** ENDING LOGGING AT Wed Jun 23 02:59:56 2010