**** BEGIN LOGGING AT Sun Feb 07 02:59:58 2021 Feb 07 22:08:17 Hi folks... anybody here able to help out with getting a usb PID under the openmoko VID? Feb 07 22:14:44 azonenberg: hi. I think I can try but not right atm. Do you know there's also pid.codes? Feb 07 22:15:32 This isnt super urgent, the project has been going on for a fair bit of time already Feb 07 22:15:43 FFY00: same about your request. Feb 07 22:15:46 This is for my open hardware oscilloscope probes, we'll be using some custom USB PD commands to power them Feb 07 22:16:05 I need to check if I still can edit the wiki to add your new codes, but not right atm as it's sleep time here. Feb 07 22:16:27 For now only one PID needed because this PID is for the bridge MCU from USB PD to the analog stuff, which should be basically the same for all probes Feb 07 22:16:40 but probably best to reserve a few just in case i need them later Feb 07 22:16:48 I do not even remember by now what's the difference in requirements between openmoko and pid.codes... Feb 07 22:17:00 iirc one of them needed both firmware and hardware to be free. Feb 07 22:17:26 Everything for this project is 3-clause BSD Feb 07 22:17:29 so that's fine by me Feb 07 22:18:19 https://www.github.com/azonenberg/starshipraider the next version of the AKL-AD1 is going to be the first user of the bridge but I'd put down "active oscilloscope probe" as the description for the PID Feb 07 22:18:56 it's not too important because these devices are PD *only* and don't do much in the way of other USB stuff. They won't break if you plug them into a PC or something, but that isn't the intended usage scenario Feb 07 22:20:27 Looks like a cool project. Feb 07 22:20:45 D+ and D- will be connected in case we need them but at least initial firmware isn't even going to enumerate :p Feb 07 22:20:53 All i need is power and a few low level control messages to negotiate voltage etc Feb 07 22:54:45 my friend found this github repo which seems to be the correct place to submit right now Feb 07 22:54:45 https://github.com/openmoko/openmoko-usb-oui Feb 07 22:55:29 the wiki still has the old process, by emailing, which does not seem to be active right now Feb 07 22:55:40 I opened a PR https://github.com/openmoko/openmoko-usb-oui/pull/24 **** ENDING LOGGING AT Mon Feb 08 03:01:12 2021