**** BEGIN LOGGING AT Thu Mar 29 02:59:56 2007 Mar 29 10:49:54 florian * r6752 /trunk/target/linux/adm5120-2.6/image/Makefile: Should fix edimax generation Mar 29 11:19:53 nbd * r6753 /trunk/scripts/config/symbol.c: fix menuconfig 'deselect' statement Mar 29 11:26:37 nbd * r6754 /trunk/Makefile: run metadata scanning only once when multiple targets are specified on the command line Mar 29 11:57:46 <[mbm]> hmm .. just noticed gpl v3 draft 3 Mar 29 20:17:14 here goes nothing: Mar 29 20:17:18 [florian]: ping Mar 29 21:39:39 <[florian]> sn9_: pong Mar 29 21:41:12 hi. the rdc port page says "A 2.4 kernel based [openwrt] port is fully usable." i can only find 2.6 Mar 29 21:41:55 2.6 has the obvious problem of no boot msgs Mar 29 21:42:28 i have a unit ready and waiting to tackle a few of the problems Mar 29 21:45:39 <[florian]> sn9_: well, actually, I did not updated the kernel config that "outputs" something, but I can put a working rdc-2.4 port somewhere if you want to test ? Mar 29 21:46:17 why not both? Mar 29 21:50:40 [florian]: and a config which has support for USB ports :) Mar 29 21:51:01 let's start with the 2.4 Mar 29 21:51:12 and USB ports :P Mar 29 21:51:57 usb just needs the proper kmod, i'm sure Mar 29 21:52:17 what rdc device has usb? Mar 29 21:52:28 sitecom dc-230, sitecom wl-176 Mar 29 21:52:35 hmm Mar 29 21:52:47 those devices even have two Mar 29 21:52:48 for storage Mar 29 21:52:50 what's the flash/ram in those? Mar 29 21:53:10 dunno Mar 29 21:53:20 I should grab one of the devices and look, I guess Mar 29 22:12:03 <[florian]> sn9_: ok, I will update the kernel config which is working, for the 2.4 stuff, it is pretty obsolete :( Mar 29 22:15:18 florian * r6755 /trunk/target/linux/rdc-2.6/config/default: Working, but very minimalistic kernel config for rdc-2.6 Mar 29 22:16:47 [florian]: i don't mean the kernel config, i mean the Makefile and patches Mar 29 22:18:52 florian * r6756 /trunk/target/linux/adm5120-2.6/files/arch/mips/adm5120/memory.c: Fix warning Mar 29 22:19:28 florian * r6757 /trunk/target/linux/adm5120-2.6/files/drivers/mtd/myloader.c: Fix myloader partition table parser Mar 29 22:20:23 florian * r6758 /trunk/tools/firmware-utils/src/mkmylofw.c: Fix mkmylofw write_out_padding routine Mar 29 22:21:24 florian * r6759 /trunk/target/linux/adm5120-2.6/files/ (4 files in 2 dirs): Add definitions, add settings detection for SoCs Mar 29 22:21:45 florian * r6760 /trunk/target/linux/adm5120-2.6/files/arch/mips/ (adm5120/setup.c pci/ops-adm5120.c pci/pci-adm5120.c): Cleanup system code and use definitions Mar 29 22:22:20 <[florian]> sn9_: ok, wait a minute Mar 29 22:34:58 <[florian]> sn9_: http://downloads.openwrt.org/people/florian/rdc-2.4.tar.bz2 Mar 29 22:35:03 <[florian]> off to bed Mar 29 22:36:12 awww Mar 29 22:36:28 i was hoping to try stuff and get feedback Mar 29 22:43:09 [florian]: the airlink checksum generator is broken; i had to use the binary-only one from gemtek Mar 29 22:44:35 [florian]: that tarball you just posted fails to build, too Mar 29 22:51:34 culprit seems to be rdc-2.4/patches/001-rdc3210_flash_map.patch Mar 29 22:51:46 removing file and trying again... **** ENDING LOGGING AT Fri Mar 30 02:59:56 2007