**** BEGIN LOGGING AT Fri Jun 01 02:59:58 2012 Jun 01 03:17:19 build #28 of s3c24xx is complete: Failure [failed compile_4] Build details are at http://buildbot.openwrt.org:8010/builders/s3c24xx/builds/28 Jun 01 09:46:28 jow_laptop: i'm going to guess that on the buildbots, sane compiles properly? i get this bothersome error, which doesn't even seem to get called (or is masked) in the compile of sane via gentoo portage: http://ompldr.org/vZTFmag/pasta Jun 01 10:26:04 nbd * r32018 /trunk/package/mac80211/patches/ (300-pending_work.patch 513-mac80211_reduce_txqueuelen.patch): mac80211: merge some pending fixes Jun 01 16:30:15 uhm, is CONFIG_PACKAGE_crda needed anymore? i see i can uncheck it now.. Jun 01 16:36:11 <[florian]> no it's not Jun 01 16:39:37 neat, thanks Jun 01 18:35:14 hmm, on latest trunk, while i was applying some wan config i got "ath: phy0: Failed to stop TX DMA, queues=0x001!" on this wr703n :P Jun 01 20:46:22 Kevin`: ping Jun 01 20:46:39 ? Jun 01 20:47:07 did you receive the device from jow? Jun 01 20:47:14 no Jun 01 20:47:18 i'm not sure if he sent it yet Jun 01 20:47:20 jow_laptop: ping Jun 01 21:14:11 hauke * r32019 /trunk/package/mac80211/Makefile: mac80211: make brcmfmac depend on usb Jun 01 21:17:05 hauke * r32020 /trunk/package/mac80211/patches/ (15 files): mac80211: brcmsmac: add some patches starting to add support for some more chips Jun 01 22:03:35 anyone up for adding support for Mikrotik RB2011L ? I could send one somewhere Jun 01 22:12:27 stintel: I could give it a try Jun 01 22:12:57 I could give it a try myself but I fail to get there :P Jun 01 22:14:17 I can give the rb493/g as a reference ;) Jun 01 22:15:35 though my plan is originally to buy one when the *US comes out Jun 01 22:15:45 yeah, maybe I should have waited Jun 01 22:16:28 but then my gigE switch died and I am temporarily replacing it with one of the 2 rb2011l-in I have at hand Jun 01 22:16:45 so I was happy to have them. going back to 100Mbps is painful Jun 01 22:17:18 but routeros is horrible, wtf Jun 01 22:17:32 getting it supported shouldn't be too hard, iirc it at least already had pads for the uart or something Jun 01 22:19:48 KanjiMonster: http://routerboard.com/pdf/390/rb2011L-IN.pdf Jun 01 22:20:24 you can see the TX and RX labeled on the board Jun 01 22:20:32 top left Jun 01 22:21:30 hmm, maybe that is already rs232 so they can just add a connector for the model with the serial port Jun 01 22:21:41 where's my screwdriver Jun 01 22:22:58 the 3.3V/GND suggest to me these are TTL Jun 01 22:23:57 ah, I missed the 3v3 Jun 01 22:24:11 le sigh :) **** ENDING LOGGING AT Sat Jun 02 02:59:58 2012