**** BEGIN LOGGING AT Thu Dec 20 03:00:00 2012 Dec 20 03:05:32 Out of curiosity, is there a reason for JFFS2_FS_XATTR=y ? It seems to add considerably to my boot times on my wrt400n. Dec 20 03:06:29 how does it add to boot time? Dec 20 03:06:36 btw. it's required for overlayfs Dec 20 03:07:11 nbd, [ 6.580000] jffs2_build_filesystem(): erasing all blocks after the end marker... done. [ 18.520000] jffs2: notice: (506) jffs2_build_xattr_subsystem: complete building xattr subsystem, Dec 20 03:07:20 heh Dec 20 03:07:37 that doesn't mean that xattr has anything to do with the delay Dec 20 03:08:47 it's not too important, but if it was a simple =n I was going to do that for my next build. Dec 20 03:09:08 I don't need to reboot very often, after all Dec 20 03:10:34 during the time between those two messages it initializes the fs Dec 20 03:10:39 this delay is only on the first boot Dec 20 03:11:51 Right. It's not a "real" issue, but if I could boot 12 seconds faster, I would just because I could. Dec 20 03:15:07 check the next boot, it'll be faster than the first one ;) Dec 20 03:16:12 hah, now that I think of it I've only rebooted due to a new firmware. if it's just a one-time penalty... Dec 20 07:03:19 build #129 of brcm63xx is complete: Success [build successful] Build details are at http://buildbot.openwrt.org:8010/builders/brcm63xx/builds/129 Dec 20 09:15:30 i've had a few instances where my wan (proto dhcp) will lose it's lease for some reason and then give up ... if i later manually run udhcpc -i $WAN_IFACE, it comes back up and works fine. recently happened to r32129 on alix2. Dec 20 09:17:14 yeah, both times that i remember were r32129 Dec 20 09:18:33 Dec 17 16:20:29 24.20.221.39 netifd: wan (924): Sending renew... Dec 20 09:18:33 Dec 17 16:20:29 24.20.221.39 netifd: wan (924): Received DHCP NAK Dec 20 09:18:34 Dec 17 16:20:29 24.20.221.39 netifd: Interface 'wan' has lost the connection Dec 20 10:11:55 build #114 of x86 is complete: Success [build successful] Build details are at http://buildbot.openwrt.org:8010/builders/x86/builds/114 Dec 20 13:16:30 jow_laptop: did you say you'd prefer for xtables-addons to just break (or be disabled) for old kernels, and unconditionally update to 2.0 (for kernel 3.7+)? Should I submit a patch that does that, instead of preserving the dual-build? Dec 20 13:16:47 the dual-build isn't particularly onerous, and is easy to remove once more than 2 targets actually use 3.7 Dec 20 13:36:41 build #94 of iop32x is complete: Failure [failed shell_11] Build details are at http://buildbot.openwrt.org:8010/builders/iop32x/builds/94 Dec 20 14:10:31 juhosg r34797 trunk/target/linux/ ppc40x/config-3.6 ppc44x/config-3.6 * ppc40x/44x: disable SWIOTLB Dec 20 14:14:05 juhosg r34798 trunk/target/linux/ (6 files) * ar71xx: rename fix-ar933x-reset patch Dec 20 14:38:29 juhosg r34799 trunk/target/linux/ppc40x/ patches-3.6/004-magicbox.patch patches-3.6/001-powerpc-add-missing-NULL-terminator-to-avoid-boot-pa.patch patches-3.6/005-openrb.patch * ppc40x: add missing NULL terminator to avoid boot panic on PPC40x Dec 20 14:52:05 juhosg r34800 trunk/target/linux/ppc40x/ (10 files in 2 dirs) * ppc40x: add support for 3.7 Dec 20 14:52:07 juhosg r34801 trunk/target/linux/ (20 files in 2 dirs) * cns21xx: add support for 3.7 Dec 20 15:16:19 luka r34802 trunk/package/base-files/files/etc/functions.sh * [package] base-files: we don't need /etc/functions.sh symlink anymore Dec 20 15:30:23 nbd r34803 trunk/docs/ network-scripts.tex config.tex * docs: update remaining references to functions.sh Dec 20 15:30:27 nbd r34804 trunk/include/kernel.mk Dec 20 15:30:27 kernel: fix module packages postinst by pointing to the new functions.sh location Dec 20 15:42:55 build #91 of gemini is complete: Failure [failed shell_11] Build details are at http://buildbot.openwrt.org:8010/builders/gemini/builds/91 Dec 20 16:05:10 build #109 of avr32 is complete: Failure [failed compile_9] Build details are at http://buildbot.openwrt.org:8010/builders/avr32/builds/109 Dec 20 17:15:46 juhosg r34805 trunk/target/linux/ generic/config-3.7 generic/config-3.6 * linux: add missing symbols for 3.{6,7} Dec 20 17:15:47 juhosg r34806 trunk/target/linux/ generic/patches-3.7/132-solos-dma.patch generic/patches-3.6/132-solos-dma.patch * kernel: add solos-pci patches from 3.8 for new hardware Dec 20 18:12:11 juhosg r34807 trunk/target/linux/ ppc44x/patches-3.7/100-openwrt_flashmap.patch ppc44x/config-3.7 ppc44x/patches-3.7 ppc44x/patches-3.7/110-openwrt_dts_cmdline.patch * ppc44x: add support for 3.7 Dec 20 19:09:49 juhosg r34808 trunk/target/linux/ rb532/config-3.6 rb532/patches-3.6/002-rb532_nand_fixup.patch rb532/patches-3.6 rb532/patches-3.6/001-cmdline_hack.patch * rb532: add support for 3.6 Dec 20 19:09:51 juhosg r34809 trunk/target/linux/rb532/Makefile * rb532: switch to 3.6.11 Dec 20 19:09:53 juhosg r34810 trunk/target/linux/ rb532/patches-3.3/001-cmdline_hack.patch rb532/patches-3.3/002-rb532_nand_fixup.patch rb532/config-3.3 * rb532: nuke 3.3 support Dec 20 19:18:06 juhosg r34811 trunk/target/linux/ramips/files/arch/mips/ralink/rt305x/mach-dap-1350.c * ramips: Add USB support for DAP-1350 platform. Dec 20 19:26:33 juhosg r34812 trunk/target/linux/ rb532/patches-3.7 rb532/config-3.7 rb532/patches-3.7/001-cmdline_hack.patch rb532/patches-3.7/002-rb532_nand_fixup.patch * rb532: add support for 3.7 Dec 20 21:11:57 build #87 of octeon is complete: Failure [failed shell_11] Build details are at http://buildbot.openwrt.org:8010/builders/octeon/builds/87 Dec 20 22:12:47 build #127 of orion is complete: Failure [failed compile_8] Build details are at http://buildbot.openwrt.org:8010/builders/orion/builds/127 Dec 21 00:58:36 build #117 of rb532 is complete: Failure [failed shell_11] Build details are at http://buildbot.openwrt.org:8010/builders/rb532/builds/117 Dec 21 01:06:23 build #122 of lantiq is complete: Failure [failed compile_2] Build details are at http://buildbot.openwrt.org:8010/builders/lantiq/builds/122 Dec 21 01:09:46 build #117 of ppc44x is complete: Failure [failed shell_11] Build details are at http://buildbot.openwrt.org:8010/builders/ppc44x/builds/117 Dec 21 01:16:47 build #124 of ramips is complete: Failure [failed compile_3] Build details are at http://buildbot.openwrt.org:8010/builders/ramips/builds/124 Dec 21 02:22:12 build #113 of ar7 is complete: Failure [failed compile_5] Build details are at http://buildbot.openwrt.org:8010/builders/ar7/builds/113 Dec 21 02:29:55 build #107 of sibyte is complete: Failure [failed shell_11] Build details are at http://buildbot.openwrt.org:8010/builders/sibyte/builds/107 **** ENDING LOGGING AT Fri Dec 21 02:59:59 2012