**** BEGIN LOGGING AT Mon Jun 21 02:59:56 2010 Jun 21 12:48:34 (a Jun 21 12:48:51 how do I set a custom speed to a serial device on startup? Jun 21 12:49:14 using the setserial tool works, but I would like to do it boot-time Jun 21 13:15:47 you can add some script code on /etc/inittab file Jun 21 13:16:08 or use a custom start script on runlevel Jun 21 13:16:48 serp_ uh missed your nickname on my post Jun 21 13:18:39 is the order in which commands in inittab are run? Jun 21 13:18:46 is the order specified* Jun 21 13:20:58 yes , on each rcX.d directory there are some soft link Jun 21 13:21:16 http://en.wikipedia.org/wiki/Runlevel Jun 21 13:21:17 :) Jun 21 13:24:12 if you need the speed change after kernel loading , this method is ok . If you need to change speed before kernel loading, u have to mod the bootloader hw init. Jun 22 00:09:12 hello Jun 22 00:09:34 I was just wondering if anyone could tell me if Angstrom will build for x86 alright Jun 22 00:10:08 I'm trying to work on a port for the OLPC XO laptop (as the OS support for it is utterly abysmal, and its too slow to run regular Ubuntu or anything) Jun 22 01:17:22 hmm, trying to get Angstrom booted on a Collie, using image built by Narcissus... it oopses or panics (can't tell which) really early on. Jun 22 01:17:48 The highest thing I can see is soc_common_pcmcia_skt_state Jun 22 01:18:49 Unfortunately, it scrolls way too fast for me to get any of the messages. Jun 22 01:20:14 er, there's a _pabt_svc+0x40/0x80 there too. Jun 22 01:25:47 hmm, if I take out the rotate:1, then I see lomocospi_do_transfer panic-ing. Jun 22 01:26:02 er, wait... sometimes it panics in completely different places. **** ENDING LOGGING AT Tue Jun 22 02:59:56 2010