**** BEGIN LOGGING AT Wed Jun 01 02:59:59 2016 Jun 01 13:17:38 why does the x15 have the giant ground lug/screw on it? Jun 01 14:33:57 Hello I am trying to extract emmc contents to memory card for my element14 beaglebone. I did follow instructions mentioned on http://elinux.org/BeagleBone_Black_Extracting_eMMC_contents, but it is not working Jun 01 14:38:41 can someone help me wit this please. Jun 01 20:31:11 Hi I Jun 01 20:31:27 I bought recently a BBB from Element14 Jun 01 20:31:36 it is not detected on BBB website Jun 01 20:31:45 How to proceed ? Jun 01 20:32:03 Can anyone give me some suggestions Jun 01 20:32:04 ? Jun 01 20:32:11 do the leds blink? Jun 01 20:32:14 yes Jun 01 20:32:20 I think its booting up Jun 01 20:32:44 but the steps mentioned on website doesn't turn GREEN Jun 01 20:32:54 does your PC show an additional network interface when it's connected over USB? Jun 01 20:33:10 yes Jun 01 20:33:22 does it get an IP address? Jun 01 20:33:33 Yes Jun 01 20:33:38 it is assigning an IP Jun 01 20:34:17 what IP does it assign? Jun 01 20:34:52 169.254.157.245 Jun 01 20:35:12 that's APIPA, not the IPv4 address that it should assign Jun 01 20:35:19 which OS is your PC running? Jun 01 20:35:44 Windows 8.1 Jun 01 20:36:09 I downloaded the drivers from website 64-bit Jun 01 20:36:20 is your PC behind a NAT router? Jun 01 20:36:59 there is not NAT device Jun 01 20:37:30 its directly connected to router Jun 01 20:37:36 ok, so the PC is not connected to a network with an IPv4 address like 192.168.7.xxx? Jun 01 20:37:53 no Jun 01 20:38:16 then assign the USB network interface the address 192.168.7.1 with netmask 255.255.255.0 Jun 01 20:38:22 no dns, no default gateway Jun 01 20:40:12 Thanks Jun 01 20:40:14 it works Jun 01 20:40:33 But, on my friend's PC , USB network is not getting detected Jun 01 20:43:18 are you there ? Jun 01 20:47:57 gee **** ENDING LOGGING AT Thu Jun 02 02:59:58 2016