**** BEGIN LOGGING AT Fri Nov 27 02:59:56 2020
Nov 27 20:33:41 <set_> @zmatt: Whenever you get around to it, will you please let me know the steps I should take to complete the firmware install?
Nov 27 20:33:58 <zmatt> I replied on your github issue
Nov 27 20:34:16 <set_> Okay. Thank you. Off to look.
Nov 27 20:35:12 <set_> Nice. I will test it now.
Nov 27 20:35:26 <set_> Should I update you if the script acts funny again?
Nov 27 20:36:05 <set_> or...should I post in the issue on github?
Nov 27 20:39:35 <set_> It seems that did everything correctly.
Nov 27 20:39:40 <set_> Off to test the motors.
Nov 27 20:44:08 <set_> It works. Nice!
Nov 27 20:44:25 <set_> I am not sure what you know but it works like it is brand new again! Yes! Thank you.
Nov 27 21:14:28 <wiebel> As I|d love to use a BB AI as a gadget, esp. as a HID device which does not need much bandwidth, I was wondering it's possible to utiliye the USB 2.0 A Connector as a USB client and this still beeing able to have the USB3 via th C connector available for high bandwidth applications?
Nov 27 23:41:45 <set_> What happens when the computer that the BBB is plugged into keeps stating, "Power Surge on USB Port"?
Nov 27 23:42:30 <set_> I cannot figure out what is going on. The board does not boot and I am receiving this error on the Host Port.
Nov 27 23:43:59 <set_> Okay. So, it boots just not w/ the Motor Bridge Cape on it.
Nov 27 23:44:00 <set_> Phew.
Nov 28 00:07:53 <zmatt> set_: it maens you're drawing more power than the usb port can supply
Nov 28 00:08:55 <set_> Right. I understand but I cannot figure out why. I plugged in the battery and used the battery on the Motor Bridge Cape.
Nov 28 00:09:26 <zmatt> wiebel: no.  for one, a usb device needs vbus detection, which is impossible on a usb host port since it's a vbus output
Nov 28 00:13:12 <set_> So, I guess just using the BBGW and Motor Bridge Cape is not going to work w/ USB only while debugging.
Nov 28 00:14:03 <zmatt> on a usb port of this particular computer
Nov 28 00:14:35 <set_> Right, okay. I tried two separate computers and the same output was present.
Nov 28 00:16:34 <set_> I then tried the BBGW by itself. It worked and not w/ the Motor Bridge Cape.
Nov 28 00:16:39 <set_> So, this is good news and bad news.
Nov 28 00:40:02 <set_> What are the possibilities on making the Motor Bridge Cape work now w/ a BBB?
Nov 28 00:40:23 <set_> or BBGW?
Nov 28 00:41:54 <set_> Hmm.
Nov 28 00:42:34 <set_> It works w/ another board but not w/ the old board that I used to write to the STM onboard the Motor Bridge Cape. Is that odd?
**** ENDING LOGGING AT Sat Nov 28 02:59:56 2020