**** BEGIN LOGGING AT Sat Jan 08 02:59:56 2022
Jan 09 00:01:32 <set_> aw!
Jan 09 00:05:37 <set_> I am trying to figure out where I can place on a motor on this chip: https://imgur.com/a/ZwBS0Bg
Jan 09 00:05:55 <set_> So far, it is for other things.
Jan 09 00:06:06 <set_> Can you see where I would put a DC motor on this chip?
Jan 09 00:10:31 <set_> The idea is this...
Jan 09 00:12:29 <set_> I am using a controller, i.e. UC2637. The motor "driver," this LM1949, is supposed to handle different things like fuel injection but I am using it for a dc motor driver(s).
Jan 09 00:12:47 <set_> I was going to use the PowerCape for this idea.
Jan 09 00:13:10 <set_> And two more power sources, w/ the PowerCape, was the idea.
Jan 09 00:14:08 <set_> So, the PowerCape needs a DC barrel jack into the BBBW to work. This is done. The output of 5v to GND is done w/ the Cape also.
Jan 09 00:15:42 <set_> The issue so far is that I am not completely sure about ideas relating to connections. PWR, GND, all the circuitry, and how I can incorporate the PowerCape into it has been an issue so far. Do you see any ideas off hand?
Jan 09 00:18:31 <set_> I also have a ULN2002A darlington tran. array in chip form.
Jan 09 00:20:06 <set_> Would I use common cathode or common emitter for the darlington array?
Jan 09 01:35:15 <set_> This array is givin' me the willies! Is there a simplified array use outside of guess work?
Jan 09 01:36:22 <set_> Tryin' to tie in arrays to arrays is not easy b/c of the circuit already being integrated.
Jan 09 01:53:16 <set_> okay so...w/out the integrated array, would this be easier? https://imgur.com/a/vnhHKvv
Jan 09 02:04:54 <set_> NPN. Dang it. I have MOSFETs. Back to the ole, drawing board. Blah.
Jan 09 02:05:00 <set_> Forget what I described here.
Jan 09 02:15:48 <set_> Okay, I have some BJT NPN trans. here. Is there a way to use these instead of the darlington trans. listed in the datasheet?
**** ENDING LOGGING AT Sun Jan 09 02:59:56 2022