**** BEGIN LOGGING AT Fri Apr 01 02:59:56 2022 Apr 01 04:04:21 thanks Apr 01 04:04:44 it only works with certain versions of the bbg linux images Apr 01 21:05:21 I tried to put new firmware on my beagle board which bricked it. Is there any way to revert it to factory settings? Apr 01 21:26:14 Guest9883: does it boot? Just reflash it.. Apr 01 21:27:22 How do I go about doing that?  I tried with the sd card and nothing happened. Apr 01 21:28:02 Which Board? Which Image did you write to the microSD with etcher.io, did you hold the "boot" button before pluggin in power? Apr 01 21:30:12 I have a beagle bone black and I tried to flash it with "AM3358 Debian 10.3 2020-04-06 4GB SD IoT". Apr 01 21:30:51 so, that is standalone image, your board should now be 'booted' on the microSD... Apr 01 21:31:06 are teh led's flashing.. Apr 01 21:31:38 The LEDs are not flashing and when I removed the sd card nothing changes. Apr 01 21:32:10 "standalone" image... once you removed the SD card, i'd expect it NOT boot... Apr 01 21:32:38 Stick it back in, hold the "Boot" button, and wait for it to boot.. Apr 01 21:33:43 Nothing happened.  The boot button is S2 correct? Apr 01 21:34:18 its' the one next to the microSD connector... Apr 01 21:34:35 plug in microSD, hold S2 down... Insert power... Wait till led turns on.. lift up finger on s2.. Apr 01 21:36:19 I tried that.  Nothing again.  I will try to rewrite the image to the sd card and see if that fixes it. Apr 01 21:36:30 did you use etcher.io ? Apr 01 21:36:50 I used balenaetcher Apr 01 21:37:00 same thing.. Apr 01 21:37:17 ok Apr 01 21:46:38 I reflashed the card and it worked this time.  Thanks for your help.  I was quite confused.  Best Apr 01 21:47:24 Thank you. Apr 01 22:05:17 zmatt: 2022-04-01 images are out, it has 5.10.x with the uio optional: uboot_overlay_pru=AM335X-PRU-UIO-00A0.dtbo in /boot/uEnv.txt **** ENDING LOGGING AT Sat Apr 02 02:59:57 2022