**** BEGIN LOGGING AT Sun May 08 23:59:57 2005 May 09 13:02:23 hi May 09 13:05:45 one quick question...when i try to install the unslung firmware it says that i shall Enter maintenance mode, but i cant find it under Administation/Upgrade May 09 13:07:54 that is only if you are upgrading from a 3.x unslung May 09 13:08:06 which it should state in the README May 09 13:08:45 ah, my fault..thanks May 09 13:09:18 np May 09 13:09:26 have fun unslunging... :) May 09 13:11:37 thanks :) May 09 17:32:49 hey there, anyone about? May 09 17:33:15 hello, Byron May 09 18:50:26 Alright, I'm a bit confused, .. I'm going to re.. slug my NSLU2, and have already formatted the External HD using the 3.18 firmware previously.. how do I upgrade properly, ensuring that I use the HD for ipkg updates and the like, instead of downloading to the slug again? May 09 18:51:03 The NSLU2 currently has Linksys firmware, and I think I can just re-flash, ..but, am confused on whether to have the HD attached, or not .. May 09 18:54:10 *always* flash without hd attached May 09 18:54:23 unless of course, you want to go through the recovery process again May 09 18:54:30 just for the the fun of it May 09 18:54:56 no, not that.. never that May 09 18:55:15 and, how do I check to make sure any ipkg commands are using the HD, and not the local slug? May 09 18:55:45 well, when you unsling *after* the firmware flash, the hd will receive the /opt folder May 09 18:56:07 which is where all ipkgs are installed May 09 18:56:07 ahh, ok, that's where my confusion lies May 09 19:13:49 alright, all upgraded, ready to add a HD May 09 19:18:30 :) May 09 19:18:48 just follow the README (I worked pretty hard on that sucker...) May 09 19:18:59 hehe, doing it now May 09 19:43:26 looks good, Byron May 09 19:43:35 thanks again! May 09 19:45:15 np **** ENDING LOGGING AT Mon May 09 23:59:56 2005