**** BEGIN LOGGING AT Thu Dec 20 02:59:57 2007
Dec 20 16:21:39 <prpplague> drath: ping
Dec 20 16:25:19 <drath> hey prpplague 
Dec 20 16:25:29 <prpplague> drath: hey question
Dec 20 16:25:56 <prpplague> drath: if i was doing a ft2232d to jtag with just 3.3v support, can i safely ignore nOE functionality?
Dec 20 16:26:14 <prpplague> drath: or is there some aspect of the openocd code that is dependent on that?
Dec 20 16:27:44 <drath> prpplague: nope, the original USBJTAG-1 connected directly from the ftdi pins to the jtag pins
Dec 20 16:28:01 <prpplague> drath: ahh ok
Dec 20 16:28:08 <prpplague> drath: jsut wanted to make sure
Dec 20 16:28:35 <drath> prpplague: the nsrst line can still be open-drain by switching between input and output mode
Dec 20 16:28:36 <prpplague> drath: prototyping a small Hammer carrier board with the ft2232 onboard
Dec 20 16:28:54 <drath> prpplague: the nail?
Dec 20 16:29:02 <prpplague> yea
Dec 20 16:29:55 <prpplague> drath: got most the schematic done
Dec 20 16:30:03 <prpplague> drath: jsut a few questions on the ft2232 stuff
Dec 20 16:30:21 <prpplague> drath: thoughts?
Dec 20 16:31:02 <drath> prpplague: i'm on my way home, should be back online in 20 minutes
Dec 20 16:31:09 <prpplague> drath ok, np
Dec 20 16:50:38 <drath> prpplague: re
Dec 20 17:12:29 * prpplague returns
Dec 20 17:14:56 <prpplague> drath: thoughts on the nail board?
Dec 20 17:15:13 <prpplague> drath: basically its just a usbjtag board that the hammer plugs into
Dec 20 17:15:23 <prpplague> drath: just trying to decide what else to put on the board
Dec 20 17:15:43 <prpplague> drath: several people what a usb host and a usb slave, others want a 10baseT connection
Dec 20 17:34:46 <drath> prpplague: are you going to connect the second ft2232 port to the serial?
Dec 20 17:34:56 <prpplague> drath: indeed
Dec 20 17:35:03 <prpplague> drath: directly to the hammers console port
Dec 20 17:35:50 <prpplague> drath: probaby use ACBUS[3:0] connected to some of the GPIO's on the hammer
**** ENDING LOGGING AT Fri Dec 21 02:59:56 2007