**** BEGIN LOGGING AT Thu May 20 03:00:01 2010
**** BEGIN LOGGING AT Thu May 20 03:51:34 2010
May 20 15:12:26 <ferar> hi, when I load my vmlinux to SDRAM "tftp 30_000_000 vmlinux" and then after loading I do go 30_000_000  (nothing happens!). However If I write the vmlinux after loading to NAND (i.e., nand write.i 30000000 40000 1F1F800), reset the board and let u-boot load that vmlinux all works fine!
May 20 15:13:04 <ferar> how can I launch vmlinux from specific SDRAM address?
May 20 15:16:47 <Weaselweb> ferar: i hope you dont type 30_000_000 with underscores
May 20 15:16:58 <ferar> no of course :/
May 20 15:17:56 <Weaselweb> is there a specific reason you use go instead of bootm?
May 20 15:18:06 <ferar> no
May 20 15:18:20 <Weaselweb> but this seem be more a problem of u-boot itself, feel free to join #u-boot
May 20 15:19:09 <ferar> ok thanks, let me check with them
**** BEGIN LOGGING AT Thu May 20 16:18:43 2010
May 20 16:21:52 <ferar> MMU=enabled, that means virtual memory addressing is on correct?
May 20 16:48:27 <wookey> yes
May 20 17:14:29 <ferar> wooky: fine, is there is an instruction in telnet openocd session to like show current memory map configuration?
May 20 17:29:33 <i__> ferar: mdb
**** ENDING LOGGING AT Fri May 21 02:59:57 2010