**** BEGIN LOGGING AT Thu Dec 09 02:59:57 2010
Dec 09 06:38:44 <kerio> my sheevaplug is dead.... what do i do?
Dec 09 17:17:47 <Thell_> on the gurplug server plus there is a two pin power header between the unsanp and reset switch, it outputs 1V 1mA...  any idea wat it is meant to be used for?
Dec 09 17:19:31 <kerio> Thell_: even *more* heat, probably
Dec 09 17:19:59 <Thell_> :P
Dec 09 17:20:33 <Thell_> I do have it down to idling at ~ 60F
Dec 09 17:22:32 <kerio> i have my sheevaplug running at ambient temperature
Dec 09 17:22:33 <kerio> because it's broken :(
Dec 09 17:22:38 <Thell_> I was thinking it may be a power switch trigger for attached sensors
Dec 09 17:22:44 <kerio> and it's not really running
Dec 09 17:22:44 <Thell_> :(
Dec 09 17:23:35 <kerio> yeah
Dec 09 17:33:04 <Tootoot222> Thell_: the fan seems to fit perfectally
Dec 09 17:33:21 <Tootoot222> even though there's a connection on the power going to the board
Dec 09 17:33:46 <Tootoot222> perhaps if the power could be modulated on that port you could ajust the fan speed
Dec 09 17:37:15 <Tootoot222> also, it apparently doesn't short when you plug the fan into it, as i'm still alive here XD
Dec 09 17:37:41 <Tootoot222> it also didn't turn the fan on, but it didn't turn on when i plugged it into its actual header either
Dec 09 17:55:38 <Thell_> Tootoot222: I haven't been able to find _any_ doc even stating that the header is there.  It seems to come on as soon as power goes to the board so I'm guessing there isn't any 'controller'
Dec 09 18:49:47 <Tootoot222> Thell_: there's not even a hole for it in the case, so it probably wouldn't have been advertised
Dec 09 18:49:51 <Tootoot222> since it's not for use
**** ENDING LOGGING AT Fri Dec 10 02:59:57 2010